Physics & Astronomy Faculty Publications
Soot combustion dynamics in a planar diesel particulate filter
Document Type
Article
Publication Date
4-1-2009
Abstract
The dynamic features of soot combustion on a single layer, planar diesel particulate filter (DPF) were studied using IR imaging. At a feed temperature of 635 °C, the soot combustion rate was uniform all over the surface at low oxygen concentrations. At higher oxygen concentrations, local ignition occurred at either one or several locations. The maximum temperature rise of the moving fronts (>100 °C) was much higher than those attained during uniform combustion. The temperature fronts bounding an ignited zone propagated on the surface. Their peak temperature and velocity changed as they moved on the surface. The maximum temperature of a downstream moving front exceeded that of the corresponding one moving upstream. At a soot loading of 10 g/L, a hot zone formed close to the end of the DPF and the bounding temperature front propagated upstream until it conquered the whole surface. At a soot loading of 20 g/L, the position and number of the hot zones strongly depended on the oxygen concentration. In general, increasing either the oxygen concentration or the soot load increased the moving front temperature and velocity. The flow rate affected the location of the ignition point for soot loading of 10 g/L but not for 20 g/L. © 2009 American Chemical Society.
Recommended Citation
Chen, K., K. S. Martirosyan, and D. Luss. "Soot combustion dynamics in a planar diesel particulate filter." Industrial & engineering chemistry research 48, no. 7 (2009): 3323-3330. https://doi.org/10.1021/ie8015544
First Page
3323
Last Page
3330
Publication Title
Industrial and Engineering Chemistry Research
DOI
10.1021/ie8015544

Comments
Copyright 2009 American Chemical Society