Theses and Dissertations
Date of Award
8-1-2026
Document Type
Thesis
Degree Name
Master of Science in Engineering (MSE)
Department
Mechanical Engineering
First Advisor
Constantine Tarawneh
Second Advisor
Heinrich Foltz
Third Advisor
Arturo Fuentes
Abstract
Approximately 40% of freight transportation in North America occurs over more than 140,000 miles of rail, and this share is expected to increase. Despite the efficiency of rail, current loading practices rely heavily on weigh bridges or instrumented track sections at fixed locations, limiting load measurements to specific routes and points. These constraints result in rerouting, delays, congestion, and an inability to continuously monitor railcar loads. Improving loading practices can enhance both operational efficiency and safety by reducing load imbalances and overloading that contribute to bearing, wheel, and track degradation. An onboard wireless load sensor addresses these limitations by providing continuous, real-time load measurements during loading, transit, and unloading. Previous laboratory studies demonstrated accurate load measurements using a strain-gauge-based sensor embedded between the bearing shear pad and adapter. This work focuses on optimizing the sensor for field readiness, including sensor geometry, mounting, calibration procedures, expected field conditions, and adaptation to multiple shear-pad variants.
Recommended Citation
Aguila, D. E. (2026). Development and Validation of a Strain Gauge Based Sensor Integrated into a Bearing Shear Pad for Continuous Load Monitoring of North American Freight Railcars [Master's thesis, The University of Texas Rio Grande Valley]. ScholarWorks @ UTRGV. https://scholarworks.utrgv.edu/etd/1999

Comments
Copyright © 2026 Diego Eliam Aguila. All Rights Reserved. https://proquest.com/docview/3409005262